Neopost SA50S User Manual page 20

If your print medium exceeds the holding capacity of the two contact
brackets supplied, a medium and a long contact bracket are also
available (see p. 38 – "Accessories") as an alternative to the front contact
bracket.
You can see which contact brackets are used for the various format sizes
from the overview tables of the PAPER SIZE parameters on p. 31 and
from Section 9.1 "Adjustable widths of the contact brackets" in the annex.
2. Adjusting the guide bars
•
Place a single sheet of paper into the feed tray.
•
Arrange the bar in the middle between the two contact brackets.
•
Push the plastic runner (riffling aid) along the guide bar up to the
paper so that it just touches it.
•
Riffle the paper stack so that the lowest sheet can be pulled in first
and then place it onto the guide bar.
•
Push the plastic cross-bar of the guide bar right up to the paper
stack. The lowest sheet of paper must just touch the cross-bar.
For high stacks of large-format medium (e.g. C4), use bar
R0612.3.051 and stack extender R0612.1.040 (cf. Section 7 -
Accessories).
Now check that the print medium is fed in correctly. Let a media stack
traverse the printer with the aid of the paper transport function in off-line
mode as follows:
Warning! Never touch the inside of the printer while it is
running.
•
If the printer is not in off-line mode, press the start key and switch
the printer OFF.
•
Press the pap key: the medium is transported or ejected. When the
pap key is pressed again, the paper transport is stopped.
User Guide SA50S
NEOPOST Address Printer
20