Adjusting The Printer To The Medium - Neopost SA50S User Manual

•
Now press the start key: the display changes:
Do you want to measure the paper size now?
Press enter key = YES. Press end key = NO.
Keep the enter key pressed down until an (L) appears on the display!
(The paper length has now been measured and locked.)
•
Press the end key.
The printer is now ready for operation:
The first line shows the ink level, then the set font and size as well as the
counter status.
The second line shows ON for on-line mode (OFF for off-line), the print
quality, the configuration and the print direction.
Print direction Nor means that the address is printed in normal read
mode – seen from the operator side, and Rev means that the address is
rotated by 180° when it is printed.
Use the start key to switch the printer to off-line mode and return to on-
line mode by pressing it again.
In on-line mode, all other keys are locked. A detailed description of the
key functions may be found in Section 6 – Programming mode.

5.7 Adjusting the printer to the medium

To ensure that a correct and well-defined print-out appears in exactly the
right place on the medium, you must adjust the printer to the print
medium used. The printer processes various thicknesses (up to 2 mm)
and various formats (from postcard size to B4 format, with special
accessories up to format C3). This means that the thickness and format
must be adjusted. For this step, keep the print media which you wish to
use next in readiness.
User Guide SA50S
NEOPOST Address Printer
Set Paper Size Now?
Enter=YES End=NO
100% Cour12 00000
On 600DPI Set1U Nor
16