Script And Printer - Neopost DS-600i User Manual

To Contents

5.10 Script and Printer

A script file is used to link the DS-600i and the DEP. Commands from the inserter are
sent Via serial cables to the Flexmail PC (this runs the script file within the project)
these commands are then converted to appropriate printer commands (PCL).
The script file has been developed by NTL to work in-line with the DS-1200. The scrip
file allows for five modes of operation (Pass-through, Mail shot, Mail Shot (no reset),
Matching and Matching Dynamic) as well as the ability to clean the print heads, clear
the print buffer and handle any type of font.
The printer for the Flexmail PC should already be defaulted to 'Neopost AS-3060A'. It is
important to ensure this is true for all projects
If you are using the NTL Generic template the correct script and printer will already be
defined for your project. However, to change the script or modify it at a later date
proceed as follows:-
Navigate to the Print tab. Make sure the 'Master' script is shown as 'NTL4i'. Make sure
the printer is set to 'Neopost AS-3060A'
If either of these are not true then select the drop down arrow to the right of the
associated box and select the required script/printer or browse to the required location.
Note.
Before you can start running Flexmail the application needs to start receiving
commands from the script and sending instructions to the printer. To do this you need
to press the 'To Printer' button in the Print tab.
Page | 32