Projector Address; Controlling The Projector - Barco Reality SIM 6 Ultra II Owner's Manual

4. Getting started
VIDEO 3 S-VIDEO 4 SDI 5 IEEE 1394 6 TRIG MOUSE
SDO
R G B H/C V 1 COMPUTER 2 MONITOR
Image 4-6
RCU directly to the IR sensor

4.6 Projector Address

4.6.1

Controlling the projector

Projector address
Address installed in the projector to be individually controlled.
Common address
Default address. Projector will always execute the command coming from a RCU programmed with that common
address.
Why a projector address ?
As more than one projector can be installed in a room, the separate projector should be separately addressable with an RCU or
computer. There for each projector has its own address.
Set up an individual Projector Address.
The set up of a projector address can be done via the software. See 'Change projector address' in chapter 'Service mode'.
Projector controlling.
Every projector requires an individual address between 0 and 255 which can be set in the Service mode.
When the address is set, the projector can be controlled now:
• RCU for addresses between 0 and 9.
• computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
36
RC
RS232 IN RS232 OUT COMM. PORT
AUDIO IN A AUDIO IN B AUDIO IN C AUDIO IN
45ø 45ø
F3
F2 F4
F1 F5
ADJ EXIT
ENTER
PAUSE TEXT
PHASE
9 0
SHARPN
7 8
TINT
5 6
COLOR
3 4
BRIGHTN
1 2
CONTR
TREBLE BALANCE
BASS VOL
45ø 45ø
F3
F2 F4
F1 F5
ADJ EXIT
ENTER
PAUSE TEXT
PHASE
9 0
SHARPN
7 8
TINT
5 6
COLOR
3 4
BRIGHTN
1 2
CONTR
TREBLE BALANCE
BASS VOL
R5976707 REALITY SIM 6 ULTRA II 01/02/2005