7. Service Mode
The following items will be displayed:
•
Type of projector: BarcoReality SIM6 Ultra II
•
Proj. address: To change the address of the projector, see "Projector Address", page 36
•
Software version
Configuration:
-
front/ceiling
-
front/table
-
rear/ceiling
-
rear/table
•
Baud rate PC: transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must
be the same as the baud rate of the connected computer. When there is a difference, consult 'Change Baudrate PC' in this
chapter.
•
Text: Indicates if the on screen text information (picture setting textboxes: contrast,...) is enabled or not
•
Projector Serial number: indicates the fabrication number of the projector. This number can be useful when calling for technical
assistance.
•
Projector Run Time: gives the total run time since the first start up. All projectors leave the factory with a run time of approxi-
mately 24 hours.
What can be seen on the BarcoReality SIM6 Ultra II Options screen ?
Following options are indicated as active or inactive (ON/OFF)
•
Soft edge
•
TDR: Transport Delay Reduction
•
TMR: True Motion Reproduction
•
Uniformity
•
Motorized dimming
•
Rugged
•
Night Mode
•
Warping
•
Gray Level Definition
•
Dynacolor
•
Active Stereo Compatibility
•
Field Stretch
•
Video
•
CLO
7.4.2
Displaying the identification screen
Start up
1. Push the cursor key ↑ or ↓ to highlight Identification.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ.ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
I2C DIAGNOSIS
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-4
2. Press ENTER to display the Identification screen.
IDENTIFICATION
TITLE PAGE
SIM OPTIONS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-5
184
R5976707 REALITY SIM 6 ULTRA II 01/02/2005