Panel Adjustments - Barco Reality SIM 6 Ultra II Owner's Manual

How to Initialize Display Blanking?
1. Push the cursor key ↑ or ↓ to highlight Initialize.
DISPLAY BLANKING
ADJUST
ACTIVE [ON]
INITIALIZE
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 7-62
2. Press ENTER to set the Display Blanking settings to 0.
3. Press EXIT to return to the Service Mode menu.

7.18 Panel Adjustments

C
AUTION
All panel adjustments are factory adjusted. If not really necessary, do not touch any of these adjustments.
They are useful when a new panel is installed.
Start up
1. Push the cursor key ↑ or ↓ to highlight Panel Adjustments
SERVICE
UNIFORMITY
ELECTRONIC CONVERGENCE
DYNACOLOR
GRAY LEVEL DEFINITION
PURITY
DISPLAY BLANKING
PANEL ADJUSTMENT
PRESET INPUT BALANCE
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-63
2. Press ENTER to select.
The following warning will be displayed :
WARNING
PANEL ADJUSTMENTS
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return
Menu 7-64
Panel Adjustments is reserved to qualified service personnel. If you are not qualified, press EXIT to cancel the panel adjustments.
R5976707 REALITY SIM 6 ULTRA II 01/02/2005
:
Changing these settings may seriously affect the performance of the projector.
7. Service Mode
207