Lamp run time is
x
hours.
Operating the lamp
longer than
x
hours
may damage
the projector.
<ENTER> to reset the
lamp runtime.
Please replace
the lamp.
Menu 3-1
The total lifetime of the lamp for a safe operation is "x" hours max, do not use it longer. Always replace with a same type of lamp.
Call a BARCO authorized service technician for lamp replacement.
Press ENTER to reset the lamp runtime.
C
AUTION
3.3 Switching to standby
How to switch to standby?
1. Press STANDBY for 2 seconds until the messages Saving data please wait is displayed.
Saving data, please wait
Image 3-3
W
ARNING
period the LED display will show a jumping square with a dash. After one minute, two dashes will be displayed
and the projector can restart.
3.4 Switching off
How to switch off the projector?
To switch off the projector, handle as follow :
1. Press STANDBY key for 2 seconds. When the message Saving data, please wait is displayed, do not press any longer on the
STANDBY key otherwise the projector will restart.
When switching to standby the projector waits for 1 minute before it can restart again. During this period the LED display will
show a jumping square with a dash. After one minute, two dashes will be displayed and the projector can restart.
Warning: Let cool down the projector at least 10 min.
2. Switch off the projector with the power switch.
3.5 Source Specifications
BarcoReality SIM6 Ultra II Source Specifications
Critical source specifications:
•
Maximum Horizontal frequency of 115 kHz.
•
Maximum pixel frequency of 205 MHz.
R5976707 REALITY SIM 6 ULTRA II 01/02/2005
:
Using a lamp for more than its recommended life time is dangerous as the lamp could explode.
:
When switching to standby the projector waits for 30 sec. before it can be restarted. During this
3. Connections
19