The Diagram below depicts the location of the cable adjustments on each
workstation. It is imperative that you maintain the cables' proper adjust-
ment to ensure a safe and smooth operation.
99
33
99
26
Cable Adjustment for:
Adjustable Stopper (#33)
. Loosen the top and bottom Regular Hex Nuts
1/2-13 (#99).
. Move the
Adjustable Stopper (#26)
until it makes contact with the
Double Pulley Bracket
(#26).
. Re-tighten the top and bottom Regular Hex Nuts
1/2-13 (#99) to complete the cable adjustment.
Note: Be sure that the
Pulley Bracket (#26)
Adjustable Stopper
(#33).
AP-250S_AP-250D Apollo 2-Stack Gym System
AP-250S_AP-250D CABLE ADJUSTMENT DIAGRAM
27
68
Adjustable Double Pulley Plates (#27)
1. Remove the hardware from the Pulley 4 1/2 Rd (#68)
located at one of the four holes of the plates.
2. By interchanging the Pulley 4 1/2 Rd. (#68) to the next
up or down
adjustment hole this will make a one inch cable adjust-
Closed-End
ment.
3. Re-tighten the hardware for the Pulley 4 1/2 Rd. (#68)
to complete the cable adjustment.
Closed-End Double
is resting on the
Caution: The cables should be inspected and adjusted periodi
cally to avoid any slack in the cables which would, consequently
prevent any damage to the equipment or personal injury.
98
99
Adjustable Pulley Brackets (#36)
1. Loosen the bottom Regular Hex Nut 1/2-13 (#99).
2. Adjust the top Nylon Insert Lock (#98) to give the cable proper
tension.
3. Re-tighten the bottom Regular Hex Nut 1/2-13 (#99) to
complete the cable adjustment.
♦ Repeat the same procedure for the other
Bracket
5
99
1. Loosen the Regular Hex Nut 1/2-13 (#99).
2. Twist the
makes contact with the
(#26).
3. Re-tighten the Regular Hex Nut 1/2-13 (#99) to complete the
cable adjustment.
Note: Be sure that the
Bracket (#26)
(#33).
Cable Adjustment for:
Fully Fasten: Proceed to Fully Fasten all these hardware assemblies.
36
36
Cable Adjustment for:
(#36).
33
26
Cable Adjustment for:
Adjustable Stopper (#33)
Adjustable Stopper (#33)
to left or right until it
Closed-End Double Pulley Bracket
Closed-End Double Pulley
is resting on the
36
Adjustable Pulley
Adjustable Stopper
22