Table of Contents
Advertisement
41
IG. 44
Route the
Leg Extension Cable (#41)
ulley 4 1/2 Rd. (#68-Labeled A4) located on the
#5).
Note: Refer to the Cable Mapping Diagram on page 24 for
further detailed illustration of the
routing.
41
IG. 46
Next, attach the
Leg Extension Cable (#41)
late/ Selector Bar (#24)
using one Split Bolt 1/2-13 X 1 (#94) and one
plit Lock Washer 1/2" (#93).
Note: Refer to Fig. A on page 24 for further clarification of this
hardware assembly.
Fully Fasten: Proceed to fully fasten this hardware assembly.
13
5
28
A4
up and over the
Top Pulley Housing
Leg Extension Cable (#41)
24
to the
A6
FIG. 45
Next, locate the assembled
Plates (#27)
and route the
under the Pulley 4 1/2 Rd. (#68-Labeled A5). Next, continue to rout
the
Leg Extension Cable (#41)
(#68-Labeled A6).
Note: Refer to the Cable Mapping Diagram on page 24 fo
further detailed illustration of the
routing.
Top
FIG. 47
Attach the looped end of the
(#42)
to the pulley bracket of the
Cap Screw 3/8-16 X 1 3/4 (#110), two Flat Washers SAE 3/8" (#91
two Nylon Spacers 3/8 X 3/8 (#120), and one Nylon Insert Jam Loc
Nut 3/8-16 (#101).
Note: Refer to Fig. A on page 25 for further clarification of thi
hardware assembly.
AP-250S_AP-250D Apollo 2-Stack Gym System
36
A4
41
A5
27
Adjustable Double Pulle
Leg Extension Cable (#41)
up and over the Nylon Pulley 4 1/2 Rd
Leg Extension Cable (#41
2
Leg Extension Tension Cabl
Base Frame (#2)
down an
42
using one Hex Hea
Hide quick links:
Advertisement
Table of Contents
