TuffStuff AP-250S Owner's Manual page 10

5
17
IG. 28 Using a rubber mallet, insert one
hrough the holes of the Press Bar Selector Housing (#17)
hrough the receptacle of the
Axle 1 X 8 1/8 (#18) is flush with both sides of the
ousing (#17).
Note: It is recommended to grease the
(#18) with multi-purpose grease prior to assembling.
69
17
69
IG. 30 Secure the two Pivot Axles 1 X 8 1/8 (#18)
Bar Selector Housing (#17)
se the Supplied Hex Key 3/16 (#126) for securing these Set Screws
/8-16 X 1/2 (#69) into the threaded sockets on the
ousing (#17). Next, clean the ends of the
#18) and apply four 1" Rd. Silver Mylar Decals (#131–Not shown).
hese decals are used to hide and protect the ends of the axles.
9
18
Pivot Axle 1 X 8 1/8 (#18)
Top Pulley Housing (#5) until the
Press Bar Selector
Pivot Axles 1 X 8 1/8
69
69
using four Set Screws 3/8-16 X 1/2 (#69).
Press Bar Selector
Pivot Axles 1 X 8 1/8
FIG. 29
and (#86) into the tube-ends of the
Pivot Bar (#1)
into place using the push-pull pin 1/2 X 3 1/2 (#73). Next, using
rubber mallet, insert the
Selector Housing (#17)
to the Press FIG. 31
the Press Bar Selector Housing (#17)
Screw 3/8-16 X 2 3/4 (#107), two Flat Washers SAE 3/8" (#91), an
one Nylon Insert Jam Lock Nut 3/8-16 (#101).
17
Using a rubber mallet, insert two Plastic Insert Caps 2" Sq
Press Bar
up into the Press Bar Selector Housing (#17)
Pivot Axle 1 X 8 1/8 (#18)
and through the
Note: Refer to Fig. 83 on page 30 for further clarification of thi
assembly.
17
C3
Next, attach two Pulleys 4 1/2 Rd. (#68-Labeled C3, C5) t
AP-250S_AP-250D Apollo 2-Stack Gym System
18
1
85
(#1). Next, insert the Pres
and support i
into the Press Ba
Press Bar (#1).
C5
using one Hex Head Ca