TuffStuff AP-250S Owner's Manual page 21

10
70
30
IG. 72 Next, insert the
eceptacle of the Adjustable Back Pad Bracket
ng tape to center the Foot Roll Tube 1 X 27 (#30)
Back Pad Bracket (#10). Next, secure the
#30) to the Adjustable Back Pad Bracket (#10)
/4-20 X 1/4 (#70).
Note: Refer to Fig. 85 on page 30 for further clarification of this
hardware assembly.
67
10
IG. 74 Attach two Metal Hinges (#67) to the axle of the
Back Pad Bracket (#10). Be sure to position the Metal Hinges (#67)
s shown above.
Note: Refer to Fig. 84 on page 30 for further clarification of this
hardware assembly.
AP-250S_AP-250D Apollo 2-Stack Gym System
Foot Roll Tube 1 X 27 (#30)
(#10). Use a measur-
with the
Foot Roll Tube 1 X 27
using one Set Screw
67
into the FIG. 73
ends of the
Adjustable using two Hex Head Cap Screws 3/8-16 X 1 1/2 (#111).
Adjustable FIG. 75
Press Back Pad (#34)
(#111). Next, attach the
Hinges (#67) using two Hex Head Cap Screws 3/8-16 X 1 1/4 (#112)
and two Flat Washers SAE 3/8" (#71).
Note: Refer to Fig. 84 on page 30 for further clarification of thi
hardware assembly.
Owner's Manual: Assembly Instructions
10
30
52
Insert two Foam Rolls 1 X 5 1/2 X 7 1/4 (#52)
Foot Roll Tube 1 X 27 (#30)
132
67
67
Attach a Rubber Bumper 3/8 X 1 1/2 (#132) to the
using one Hex Head Cap Screw 3/8-16 X 1 1/
Bench Press Back Pad (#34)
52
to the tube
and secure them into plac
34
10
Benc
to the Meta
20