Table of Contents
Advertisement
D1
IG. 4
On a flat surface, lay the
hree Pulleys 4 1/2 Rd (#68-Labeled D1,E1,E3) to the
sing three Hex Head Cap Screws 3/8-16 X 2 (#109), six Flat Washers
AE 3/8" (#91), and three Nylon Insert Jam Lock Nuts 3/8-16 (#101).
ext, affix one Hex Head Cap Screw 3/8-16 X 2 (#109), two Flat
Washers SAE 3/8" (#91), and one Nylon Insert Jam Lock Nut 3/8-16
#101) to the bracket in front of the
Note: The black boxed letters pointing to the pulleys are used
throughout this manual as reference to the Cable Mapping
Diagrams on pages 24 - 39. These black boxed letters will be
primarily used for locating certain pulleys during the cable
routing process.
89
89
14
IG. 6
Insert the
Low Row Stabilizer (#14)
he
Base Frame
(#2). Next, using a rubber mallet, insert two Plastic
nsert Caps 1" Rd. (#89) into the tube-ends of the
#14).
3
E3
D2
2
Base Frame (#2)
down and attach
Base Frame (#2)
Base Frame
(#2).
2
74
into the receptacle of
Low Row Stabilizer
85
D2
F2
2
FIG. 5
Using a rubber mallet, insert two Plastic Insert Caps 2" Sq
(#85) into the tube-ends of the
Pulleys 4 1/2 Rd (#68-Labeled A3,D2,F2) to the pulley brackets of the
Base Frame (#2)
using three Hex Head Cap Screws 3/8-16 X 1 3/
(#110), six Flat Washers SAE 3/8" (#91), and three Nylon Insert Jam
Lock Nuts 3/8-16 (#101).
14
15
31
FIG. 7
Using a rubber mallet, insert two Plastic Insert Caps 1" Rd
(#89) into the tube-ends of the
nect the
Low Row Foot Support (#15)
(#14)
using the
Foot Roll Tube 1 X 16
Tube 1X16 (#31)
to the
Low Row Stabilizer (#14)
Screw 3/8-16 X 1/2 (#69), as shown in caption above.
AP-250S_AP-250D Apollo 2-Stack Gym System
A3
85
Base Frame
(#2). Next, attach thre
14
69
15
89
Foot Roll Tube 1X16
(#31). Next, con
to the
Low Row Stabilize
(#31). Secure the
using one Se
Foot Ro
Hide quick links:
Advertisement
Table of Contents
