TuffStuff AP-250S Owner's Manual page 5

4
2
2
IG. 8 Using a rubber mallet, insert one Plastic Insert Cap w/ Groove
X 3 (#57) onto the tube-end of
Rear Upright (#4) to the Base Frame (#2)
crews 3/8-16 X 4 (#105), four Flat Washers SAE 3/8" (#91), and two
ylon Insert Lock Nuts 3/8-16 (#100).
84
11
9
IG. 10 Next, attach the Leg Extension Front Frame (#11)
eg Extension Main Frame (#9)
6 X 4 1/4 (#104), four Flat Washers SAE 3/8" (#91), and two Nylon
nsert Lock Nuts 3/8-16 (#100). Next, attach one Pulley 4 1/2 Rd. (#68-
abeled A1) and one Cable Retainer L-Shaped Bracket (#28)
eg Extension Front Frame (#11)
/8-16 X 4 1/4 (#105), one Flat Washer SAE 3/8" (#91), and one Nylon
nsert Lock Nut 3/8-16 (#100). Refer to Fig. 86 on page 30 for further
ustration of this hardware assembly.
Note: Be sure the Cable Retainer L-Shaped Bracket (#28)
positioned as shown in caption above.
AP-250S_AP-250D Apollo 2-Stack Gym System
4
57
Rear Upright (#4). Next, attach the
using two Hex Head Cap
11
A1
50
A2
9
using two Hex Head Cap Screws 3/8-
using one Hex Head Cap Screw
57
9
57
57
FIG. 9 Using a rubber mallet, insert two Plastic Insert Caps w
Groove 2 X 3 (#57) onto the tube-ends of the
Frame (#9). Next, attach one Pulley 4 1/2 Rd. (#68-Labeled A2) and
one Pulley Cover Plate (#50)
threaded socket using one Hex Head Cap Screw 3/8-16 X 1 3/4 (#110)
one Split Lock Washer 3/8" (#95), and one Flat Washer SAE 3/8" (#91)
Note: Attach the
Upright (#4)
Screw 3/8-16 X 4 1/4 (#104), two Flat Washers SAE 3/8" (#91
and one Nylon Insert Lock Nut 3/8-16 (#100). The other Bolt wi
be installed in the 2
been assembled onto the unit. Refer to Fig. 82 on page 23 fo
further clarification of this assembly.
28
to the FIG. 11 Using a rubber mallet, insert one Plastic Insert Cap 2" Sq
(#85) into the tube-end of the
attach the Leg Extension Seat Frame (#12)
Main Frame (#9)
to the (#104), four Flat Washers SAE 3/8" (#91) and two Nylon Insert Loc
Nuts 3/8-16 (#100).
Loosely Fasten: Do not completely fasten this hardwar
assembly at this time, as it will be completely fastened later in
the assembly process.
is
Owner's Manual: Assembly Instructions
50
A2
9
1
to the Leg Extension Main Frame (#9
Leg Extension Main Frame (#9)
st
using ONLY the 1 hole with one Hex Head Ca
nd
hole once the Weight Shrouds (#22)
12
85
Leg Extension Seat Frame
using two Hex Head Cap Screws 3/8-16 X 4 1/
4
st
nd
2
Leg Extension Mai
to the Rea
hav
9
(#12). Nex
to the Leg Extensio
4