TuffStuff AP-250S Owner's Manual page 8

5
IG. 20 Caution: It is strongly recommended to use another
person in assisting with this assembly.
Attach the Top Pulley Assembly (#5)
wo Hex Head Cap Screws 3/8-16 X 4 1/4 (#104), four Flat Washers
AE 3/8" (#91), and two Nylon Insert Lock Nuts 3/8-16 (#100).
Loosely Fasten: Do not completely fasten this hardware
assembly at this time, as it will be completely fastened later in
the assembly process.
19
IG. 22 Attach four Pulleys 4 1/2 Rd. (#68-Labeled D5, C7, D3, C8)
o the pulley brackets of the Top Pulley Assembly (#5)
ead Cap Screws 3/8-16 X 2 3/4 (#107), four Flat Washers SAE
/8" (#91), and two Nylon Insert Jam Lock Nuts 3/8-16 (#101). Next,
ttach another Pulley 4 1/2 Rd (#68-Labeled C1) to the
embly (#5) using one Hex Head Cap Screw 3/8-16 X 2 1/2 (#108),
wo Flat Washers SAE 3/8" (#91), and one Nylon Insert Jam Lock Nut
/8-16 (#101). Next, attach the
ulley Assembly (#5) using one Hex Head Cap Screw 3/8-16 X 2 3/4
#107), two Flat Washers SAE 3/8" (#91), and one Nylon Insert Jam
ock Nut 3/8-16 (#101).
7
3
to the Front Upight (#3)
5
C1
D5
C7
D3
C8
using two Hex
Top Pulley As-
Lat Bar Holder 2 X 3 (#19)
FIG. 21
Upright (#4)
four Flat Washers SAE 3/8" (#91) and two Nylon Insert Lock Nuts 3/8
using 16 (#100).
28
FIG. 23
one Cable Retainer L-Shaped Bracket (#28)
Top Pulley Assembly (#5)
3/4 (#110), two Flat Washers SAE 3/8" (#91), and one Nylon Insert Jam
Lock Nut 3/8-16 (#101). Be sure to position the
Shaped Bracket (#28)
to the Top
5
3
Next, attach the Top Pulley Assembly (#5)
using two Hex Head Cap Screws 3/8-16 X 3 1/4 (#106)
Fully Fasten: Proceed to align and fully fasten this hardwar
assembly and all the previous assemblies that were le
loosely fastened.
5
A4
Next, attach one Pulley 4 1/2 Rd. (#68- Labeled A4), an
using one Hex Head Cap Screw 3/8-16 X
as shown above.
AP-250S_AP-250D Apollo 2-Stack Gym System
4
to the Rea
to the pulley plate of th
Cable Retainer L