Table of Contents
Advertisement
IG. 64
Route the
Tension Cable (#40)
Rd. (#68-Labeled F1) on the
oute the cable down and under the Pulley 4 1/2 Rd. (#68-Labeled F2)
ocated on the
Base Frame
(#2), then up and over the Pulley 4 1/2 Rd.
#68-Labeled F3) located on the assembled
#27).
Note: Refer to the Cable Mapping Diagram on page 29 for
further detailed illustration of the
IG. 66
Using a rubber mallet, insert one Plastic Insert Cap 2" Sq.
#86) into the tube-end of the
ttach the
Back Pad Adjustable Tube (#47)
Back Pad (#49)
using two Hex Head Cap Screws 3/8-16 X 1 1/4
#112), and two Flat Washers SAE 3/8" (#91).
AP-250S_AP-250D Apollo 2-Stack Gym System
26
F1
27
F3
40
F2
up and over the Pulley 4 1/2
Closed-End Pulley Bracket
Double Pulley Plates
Tension Cable (#40)
86
47
49
Back Pad Adjustable Tube
to the
Leg Extension
FIG.65
(#26). Next,
Frame (#2)
X 3/4 (#117), and one Nylon Insert Lock Nut 5/16-18 (#102).
routing..
FIG. 67
(#47). Next,
the
Leg Extension Seat Frame
Owner's Manual: Assembly Instructions
27
F3
F2
Secure the end of the
Tension Cable (#40)
using one Strap Bracket #20 (#118), one Shoulder Bolt 3/
Note: Refer to Fig. A on page 29 for further clarification of thi
hardware assembly.
Insert the assembled
Back Pad Adjustable Tube (#47)
(#12).
2
to the
Bas
49
138
47
12
18
t
Hide quick links:
Advertisement
Table of Contents
