The Diagram below depicts the location of the cable adjustments on
each work station. It is imperative that you maintain the cables' proper
adjustment to ensure a safe and smooth operation.
Short Adjustable Stopper (#29)
1. Loosen the Regular Hex Nut (#90).
2. Twist the
3. Re-tighten the Regular Hex Nut (#90) to
TS-1000 Home Gym w/Adjustable High-Low Pulley System
TS-1000 CABLE ADJUSTMENT DIAGRAM
Adjustment for:
Short Adjustable Stopper (#29)
to left or right until it is making contact with
the
Closed-End Double Pulley Bracket
(#31).
complete the adjustment.
Cables should be inspected and adjusted periodically to avoid any
slack in the cables which would, consequently, prevent any dam-
age to the equipment or personal injury.
CAUTION
Adjustable Pulley Bracket (#27)
1. Loosen the bottom Regular Hex Nut (#90).
2. Adjust the top Nylon Insert Lock (#91) to give the
cable proper tension.
3. Re-tighten the bottom Regular Hex Nut (#90) t
complete the cable adjustment.
1. Loosen the two Regular Hex Nuts (#90).
2. Twist the
or right until it is making contact with the
End Adj. Double Pulley Bracket (#30).
3. Re-tighten the Regular Hex Nuts (#90) t
complete the adjustment.
1. Remove the hardware from the Nylon Pulley 4 1/
Rd. (#67-Labeled D1).
2. By interchanging the Nylon Pulley 4 1/2 Rd. (#67
to the next adjustment hole it will make one inch
cable adjustment.
3. Re-tighten the hardware for the Nylon Pulley 4 1/
Rd. (#67) to complete the cable adjustment.
Leg Extension/Abdominal Cable
1. Loosen the Regular Hex Nut (#90).
2. Thread the
out of the threaded socket of the
Pulley Bracket (#32)
Abdominal Cable (#38)
3. Re-tighten the Regular Hex Nut (#90) to complet
the adjustment.
CAUTION
Fully Fasten: Proceed to Fully Fasten these
hardware assemblies and all of the previous assem
blies that were left loosely fastened.
FULLY FASTEN
Cable Adjustment for:
Adjustment for:
Long Adjustable Stopper (#28)
Long Adjustable Stopper (#28)
Cable Adjustment for:
Closed-End Adj. Double
Pulley Bracket (#30)
Cable Adjustment for:
(#36)
Hex Tap Bolt 1/2-13 x 3 (#84)
to give the
proper tension.
Caution: Make sure the
Hex Tap Bolt 1/2
13 x 3 (#84)
is threaded at least 1/2" into th
threaded socket of the
Pulley Bracket (#32)
once the cable adjust
ment is complete.
to lef
Closed
in o
Floating Double
Leg Extension
Floating Doubl
22