TuffStuff AP-250S Owner's Manual page 15

A5
B1
IG. 48 Next, continue to route the
#42) up and over the Pulley 4 1/2 Rd. (#68-Labeled B1).
Note: Refer to the Cable Mapping Diagram on page 25 for
further detailed illustration of the
(#42) routing.
C1
IG. 50 Begin routing the
/2 Rd. (#68-Labeled C1) and into the tube of the
Assembly (#5). Then, pull the
pening at the bottom of the Top Pulley Assembly (#5).
Note: Refer to the Cable Mapping Diagram on page 26 for
further detailed illustration of the
AP-250S_AP-250D Apollo 2-Stack Gym System
42
Leg Extension Tension Cable
Leg Extension Tension Cable
5
37
Lat Cable (#37) up and over the Pulley 4
Lat Cable (#37) down through the
Lat Cable (#37) routing.
FIG. 49
to the threaded socket of the
13 X 1 (#94), and one Split Lock Washer 1/2" (#93).
FIG. 51
Top Pulley the bottom of the
using one Hex Head Cap Screw 3/8-16 X 2 1/2 (#108), two Fla
Washers SAE 3/8" (#91), and one Nylon Insert Jam Lock Nut 3/8-1
(#101). Be sure the cable is routed properly into the groove of the Pu
ley 4 1/2 Rd. (#68-Labeled C2).
Owner's Manual: Assembly Instructions
2
Attach the end of the Leg Extension Tension Cable (#42
Base Frame (#2)
Note: Refer to Fig. B on page 25 for further clarification of thi
hardware assembly.
Fully Fasten: Proceed to fully fasten this hardware assembly.
C1
Insert a Pulley 4 1/2 Rd. (#68-Labeled C2) into the slot a
Top Pulley assembly (#5)
Note: Refer to the Cable Mapping Diagram on page 26 fo
further detailed illustration of the
42
using one Split Bolt 1/2
5
C2
37
and secure it into plac
Lat Cable (#37) routing.
14