ENGINE
3.4. COOLING
3.4.1.
REMOVING THE WATER PUMP
•
In the event of noise at the bearings or oil leaks at the
cover inner drain hole, overhaul water pump.
•
Remove flywheel cover (1) with water pump from en-
gine.
•
Undo the three fasteners (3) and remove rotor cover
(2).
•
Position flywheel cover on ring base
NOTE To avoid damage to the cover surface used to the
coolant-sealing surface of the cover, position the ring bases
with its machined surface facing the flywheel cover.
•
Use a press and the drift (B) of tool 8140663 to push
the shaft and rotor out of the drive and bearings.
•
Remove the shaft washer.
•
Remove the drive.
3 - 64
Engines M192M / M191M / M245M / M234M / M282M / M281M