Fitting The Complete Flywheel Cover (Engines M245M / M281M / M234M /M282M) (125 - 200 Cc) - APRILIA M192M Workshop Manual

Engines M245M / M234M / M282M / M281M
3.2.8. FITTING THE COMPLETE FLYWHEEL COVER
(ENGINES M245M / M281M / M234M /M282M)
(125 - 200 CC)
•
Position the flywheel with its TDC mark aligned with
the mark on the crankcase.
• Prepare the flywheel cover: align marks between drive
and case cover.
• Fit the outside SAS cleaner and mount the cover.
• Fit the inside SAS cleaner.
WARNING
Make sure the two centering dowels are pre-
sent.
•
Fit the cover on the engine; fit the three rods into the
holes for the water pump drive.
WARNING
Ensure that the flywheel connector is properly
fitted.
• Tighten the cover screws.
• Connect the diaphragm to the SAS delivery pipe and
close the clamp.
• Position the air duct.
• Tighten the diaphragm and duct screws.
• Connect the cooling sleeve and close the clamp.
ENGINE
3 - 49