ENGINE
3.6.32.
ASSEMBLING THE THERMOSTAT
•
Position thermostat with the bleed hole in the highest
position.
•
Make sure that rubber seal is correctly positioned.
•
Fit thermostat cover with the union for carburetor heat-
ing tube facing the flywheel.
•
Tighten the screws to the specified torque values.
TIGHTENING TORQUE VALUES
Screws: 3 ÷ 4 Nm
3 - 118
Engines M192M / M191M / M245M / M234M / M282M / M281M