Engines M192M / M191M / M245M / M234M / M282M / M281M
•
Tighten the eleven screws (10) to the specified torque
value.
TIGHTENING TORQUE VALUES
Screws (10): 11 ÷ 13 Nm
NOTE Remove any excess of the casing-to-cylinder mating
gasket to ensure better sealing.
•
Lubricate flywheel-side oil seal.
•
Refit oil seal.
•
Install a new O-ring on pre-filter and lubricate it.
•
Install pre-filter with plug on engine. Tighten to the
specified torque value.
TIGHTENING TORQUE VALUES
Oil drain plug: 24 ÷ 30 Nm
•
Lubricate the gasket and mount the oil filter.
ENGINE
3 - 79