ENGINE
3.5.6.
CLOSING THE CRANKCASE
•
Fit inner guard (1), tighten the two screws (2) to the
specified torque.
TIGHTENING TORQUE VALUES
Screws (2): 4 ÷ 6 Nm
•
Fit the oil filter union and tighten to the specified torque
value.
TIGHTENING TORQUE VALUES
Oil filter connector (3): 28 ÷ 30 Nm
•
Position gasket (4) with centering dowels (5) preferably
on the transmission-side casing.
•
Lubricate main bearings (6), install crankshaft (7) in
transmission-side casing (8).
•
Mate the two casings (8 and 9).
NOTE When assembling the casings and the crankshaft,
take care not to damage main bearings with crankshaft-
threaded ends. For version 200 cc: set the shims in their
original position.
3 - 78
Engines M192M / M191M / M245M / M234M / M282M / M281M