Replacing The Separating Knife - Roland XC-540 User Manual

5-4 Replacing Consumable Parts

Replacing the Separating Knife

If the separating knife becomes dull, replace it with the included replacement blade.
CAUTION
CAUTION
1.
Enter the blade replacement mode.
–
MENU
SUB MENU
—
SUB MENU
MAINTENANCE
˜
MAINTENANCE
REPLACE KNIFE
™
NOW PROCESSING..
OPEN FRONT
COVER
š
FINISHED?
2.
Replace the separating knife.
–
—
Positioning
groove
76 Chapter 3 Maintenance and Adjustment
Be sure to perform operations as specified by these instructions, and never touch
any area not specified in the instructions.
Sudden movement of the machine may cause injury.
Do not touch the tip of the separating knife with your fingers.
Doing so may result in injury.
Press
Press
Press
Press
Press
Press
Press
The print-head carriage moves to a location permitting blade replacement, and
then the screen shown in the figure appears.
Open the front cover.
Preparations are complete when this screen appears.
2
1. Loosen the screw until it slips out.
2. Grasp the screw portion, and slowly pull it out in the
direction of the arrow. When doing this, do not pull it back
toward you.
1
Magnet
.
several times.
.
.
.
several times.
.
Remove the separating knife.
Install a new knife.
The knife is secured in place by the magnet.