Roland XC-540 User Manual page 34

2-2 Loading and Cutting Off Media
—
Secure the stoppers in place in alignment with the width of the media.
The stoppers number four in total. Tighten all screws.
Stopper
Important!
Make sure the media flanges are straight. Correct media feed is impossible if either of the media flanges is at an
angle.
3.
Load the media so that it is without slack.
–
—
32 Chapter 2 Operation
Roll media
OK
Loading lever
Stopper
Tighten the screws
to secure in place.
Not OK
Pull out the media.
Hold the media at the center and pull it out, being
sure to keep it straight.
Make sure all areas of the media are taut.
OK
Pull back the loading lever to secure the media
in place.
Not OK