The Machine Doesn't Run; The Printer Unit Doesn't Run; The Media Take-Up System Doesn't Run; The Media Heating System Does't Warm Up - Roland XC-540 User Manual

7-1 The Machine Doesn't Run

The Printer Unit Doesn't Run

Is the power switched on?
Switch on the printer's main power, then press the sub power
switch and make sure the sub power switch lights up.
Is illuminated?
Printing is not performed when
Pull back the loading lever, close the front cover, and press
.
Is the front cover open?
Close the front cover.
Is the top menu displayed?
If the top menu isn't displayed, output doesn't start even
when data is sent from the computer. To go to the top menu,
press , then press
Is illuminated?
When lights up, operation is paused. To resume,
press .
Has ink run out?
When printing data is sent while the screen shown in the
1 2 3 4
5 6 7 8
sounds. At the same time, operation pauses. When the ink
cartridge is replaced with a new one, printing or cutting
starts.
P.91 "Determining What Happens When an Ink Cartridge
Is Empty"
Is a message displayed on the screen?
P.137 "If a Message Appears"
P.138 "If an Error Message Appears"
Is the cable connected?
Connect the cable securely.
Is the network connection correct?
Check the port setting for the software RIP. In the software
RIP, specify the IP address assigned to the Roland-
PrintServer.
Make sure the network routing is suitable. Try connecting
the computer and the machine to the same hub, or con-
necting then directly using a crossover cable. If this makes
it possible to perform outputting, it means the problem is in
the network itself.
Make sure the green light is on. If the light is dark, the net-
work connection is not correct.
If output is impossible even though the green light is on,
make sure the IP address and other settings are correct. The
settings on both the machine and the computer must be
130 Chapter 7 What to Do If
is not illuminated.
goes dark and printing resumes.
figure is displayed, a message
appears and a warning beep
correct. Try making the settings again as you check for du-
plicate IP addresses and typing errors.

The Media Take-up System Doesn't Run

Is the cable connected?
Connect the cable for the take-up unit to the machine. To
perform take-up automatically during printing, also make
the setting for the AUTO switch.
"Setup Guide"

The Media Heating System Does't Warm Up

Is media loaded?
The media heating system does not warm up to the preset
temperature when
dia, press , and wait for the machine to warm up.
P.110 "Setting How the Media Heating System Operates"
Is the temperature of the room too low?
Use the machine in an environment where the temperature
is 20 to 32˚C (68 to 90˚F).
Green light
is dark ( by default ). Load me-