Roland XC-540 User Manual page 36

2-2 Loading and Cutting Off Media
Position the pinch rollers over the grit rollers.
If the following message appears when you close the front cover, open the front cover and check the positioning of the
pinch rollers. These must be placed over the grit rollers.
OK
Placement of the Pinch Rollers
Position the pinch rollers at locations that are not overly close to the edges of the media.
about 10 mm
Remove when not using roll media.
If roll media is allowed to stand unused in a loaded state for an extended period, the media may sag. This can cause
poor output quality and motor errors, so be sure to remove and properly store such media when not in use.
34 Chapter 2 Operation
Not OK
PINCHROLL ERROR
INVALID *** POS