4-2 Using the Take-up System
How to Take Up Media
1.
Pass the media through the printer.
Dancer roller
Load the roll media.
P.30 "How to Load Media"
2.
Fasten the media to the paper pipe.
For information on how to attach the paper tube, refer to the Setup Guide.
SETUP SHEET
TU
LOAD MEDIA
TO TAKE-UP
Move the dancer roller toward the rear.
Pull back the loading lever to secure the media in place.
Loading lever
Use
Press
.
Press
to adjust the length of the media to be pulled out.
You can adjust the length of the media in 10-millimeter steps by pressing
(To pull out media continuously, hold down the key. )
to select [TU].
Chapter 4 Operation of the Media Take-up System
.
57