Operation Panel - Roland XC-540 User Manual

Operation Panel

TEST PRINT Key
Holding this down for one
second or longer performs
a printing test.
CLEANING Key
You use this to perform
cleaning of the print
heads.
TEST CUT Key
Holding this down for one
second or longer performs
a cutting test.
CUT CONFIG Key
This displays the menu for
setting the conditions for
cutting.
Panel Notation
In this document, the keys and lights on the control panel are indicated by the following images.
MENU Key
SETUP Key
ENTER Key
PAUSE Key
CLEANING Key
TEST PRINT Key
TEST CUT Key
BASE POINT Key
CUT CONFIG Key
HEATER CONFIG Key
SHEET CUT Key
Display Screen
This displays various set-
ting menus and other in-
formation.
MENU Key
You press this to enter the
menus for various settings.
Cursor Keys
You use these to select set-
tings for menu items, to
move the media, and for
other such operations.
Cursor Keys
1-2 Part Names and Functions
BUSY Light
This lights up during out-
putting and other such op-
erations.
ENTER Key
You use this for such tasks
as enabling setting values.
BASE POINT Key
You use this when you
want to set the output-start
location. This lights up
when the set has been
made.
SETUP Key
You press this when you
load media. This lights up
when media is loaded and
the machine is ready to
perform outputting.
PAUSE Key
This pauses outputting.
SHEET CUT Key
Holding this down for one
second or longer cuts off
media.
Sub Power Switch
This switches the printer
on and off. (To switch the
printer off, you hold down
the switch for one second
or longer). This flashes
slowly when the machine
is in the sleep mode.
HEATER CONFIG
Key
You press this to make the
temperature setting for the
media heating system.
This flashes during warm-
up, then remains steadily
lighted when the preset
temperature is reached.
Chapter 1 Introduction 25