Parts Names And Functions; Front View - GRAPHTEC CE-3000-120 AP User Manual

1.2 Parts Names and Functions

Front View

Cutting mat .............. Cutting or plotting is performed on this mat.
Grit roller ................. Feeds the medium backward or forward.
Push rollers ............. Pushes the medium against the grit rollers.
Pen carriage ............ Moves the cutter pen to the left and right.
Cutter pen holder .... Hold the cutter pen and moves it up and down.
Pen holder ............... Holds the pen and moves it up and down.
Pen station .............. Used to mount the pen before it is used.
Media set lever ........ Raises or lowers the push rollers during loading of a medium.
Control panel ........... Used to operate the cutting plotter and set functions.
Parallel (Centronics) interface connector
........................ Used to connect a Centronics-compatible parallel interface cable.
USB interface connector
........................ Used to connect a USB cable.
Serial (RS-232C) interface connector
........................ Used to connect an RS-232C serial interface cable.
Stock shaft .............. Used to load roll media.
Stoppers .................. Used to hold a roll medium in place (left and right, one each).
Cutter pen holder
Cutting mat
Grit roller
Stopper
Stock shaft Push rollers
Pen holder
Control panel
Media
set lever
Pen carriage
Introduction
Pen station
Parallel (Centronics)
interface connector
USB
interface connector
Serial (RS-232C)
interface connector
1-3