Install Dimm Memory Modules; Install Tool-Less Cd-Rom Or Dvd-Rom Drive - Intel P4308CP4MHEN Quick Installation User's Manual

General Installation Process
7

Install DIMM Memory Modules

DDR3 DIMM Memory Identification:
CAUTION: Observe normal ESD (ElectroStatic Discharge) procedures
to avoid possible damage to system components.
This server board supports up to 16 DDR3 800/1066/1333/1600 ECC
UDIMM/RDIMM/LRDIMM.
DIMM
notch and
socket
bump must
align as
shown.
DDR3
Install DIMM Memory Modules ... Continued
To Install DIMMs:
A
Open both DIMM socket levers.
B
Note location of alignment notch.
C
Insert DIMM making sure the connector edge of the DIMM aligns correctly with the slot.
D
Push down firmly on the DIMM until it snaps into place and both levers close.
E
IMPORTANT! Visually check that each latch is fully closed and correctly engaged with each DIMM edge slot.
8

Install Tool-less CD-ROM or DVD-ROM Drive

A
Press the release latch and use
the finger holes to Pull out the
EMI shield.
Memory Type: Minimum of one 1 GB, DDR3 800/1066/1333 MHz ECC UDIMM/RDIMM/LRDIMM.
Other
Memory sizing and configuration is supported only for qualified DIMMs approved by Intel. For a list of
Memory
supported memory, see the tested memory list at
CAUTION: Avoid touching contacts
when handling or installing DIMMs.
Finger Holes
A
B C
Get the slides from the
chassis side.
DIMM E1 E2 F1 F2
DIMM C1 C2 D1 D2
http://serverconfigurator.intel.com/default.aspx
E
A
B
D
Attach slides to the DVD or CD-ROM drive
by pressing the slides firmly into the side
dimples on the DVD or CD-ROM drive.
5
DIMM H2 H1 G2 G1
DIMM B2 B1 A2 A1
C
D
B
C
D
Insert the drive/slide assembly
into the device bay until the
slides lock into place.