Appendix
Indicator and projector state
Check the indicator to know about the state of projector.
Indicator
POWER
LAMP
Green/Red
Yellow
Green
Flash green
* When the lamp reaches the end of its life, the LAMP indicator lights Yellow. In this case,
replace the lamp with a new one promptly.
82
WARNING
Red
In power-off state (AC power cord not connected).
In standby state. Press POWER to power on the projector.
In normal working state.
Ready to be in standby mode or the projection lamp is being cooled.
Before you power on the projector, you have to wait till the lamp is
cool enough and the power indicator stops flashing.
In power management ready mode.
Internal temperature too high, can't be powered on. When the
projector is cool enough, the temperature is restored to the normal
value and the power indicator is illuminated red, you can then power
on the projector.
Can't be powered on because error is detected. You must unplug
the power cord. Then insert it again and power on the projector. If
the projector is powered off again, you must cut off the power and
contact the local distributor or repair center. In this case, stop the
projector. Otherwise, electric shock or fire may occur.
The service life of the lamp is over. You should replace it with a new
one in time.
Red
Flash red
State of projector
Yellow
Off