Indicator And Projector State - Eiki LC-XNS2600 Owner's Manual

Indicator and projector state

Check the indicator to know about the state of projector.
Indicator
POWER WARNING
(Green/Red)
―
....Green
....Green flashes
* When the lamp reaches the end of its life, the WARNING indicator lights red.
In this case, replace the lamp with a new one promptly.
(Red)
The projector is off. (AC power cord not connected).
The projector is operating normally.
- In standby mode. Press POWER to power on the projector.
- When the projector is cool enough, the temperature is restored
to the normal value, you can turn on the projector. And the
POWER indicator stops flashing.
Internal temperature too high and can't be turned on. When
the projector is cool enough, the temperature is restored to the
normal value and the POWER indicator lights red, you can turn
on the projector .
In power management mode.
Ready for standby mode or the lamp is being cooled. Before you
turn on the projector, you should wait till the lamp is cool enough
and the POWER indicator flashes.
Can't be turned on because error is detected. You should unplug
the power cord. Then insert it again and power on the projector.
If the projector is powered off again, you should cut off the power
and contact the local distributor or repair center. In this case,
stop operate the projector. Otherwise, electric shock or fire may
occur.
The service life of the lamp is over. You should replace it with a
new one in time.*
....Red
....Red flashes
State of projector
? ....Orange
?
....Orange flashes
Appendix
....Off
61