Network - Eiki LC-XBS500 Owner's Manual

Network

Function : PC controls projector via LAN.
Preparation:
1. Equipments: PC, projector, cables
2. Connection procedures:
Connect the projector to routers or switches of the LAN by direct or cross cable. If it fails to
connect PC and projector by parallel cable, please switch to cross cable as suggested.
3. After the computer is booted and the projector is plugged in, indicator lights of LAN interface
on will flash continuously.
Operation procedures:
1 Turn on the projector.
2 Obtain network address. DHCP set is displayed as On and obtain network address
automatically.( If familiar with network, you can set DHCP as Off and obtain network
address manually.)
3 Enter network settings menu.
(1) Press MENU button on the remote control to
display screen menu. Press  button to
select Expand, then press the OK button.
(2) Press  button to select Network, and
then press the OK button to enter the network
menu.
MAC address ... Displays the MAC address
IP address .........Displays the IP address of
(3) When DHCP is set On, IP address, Subnet,
Gateway and DNS will be obtained
automatically, press the OK at "Set" to confirm
the parameters.
W hen DHCP is set Off, press the OK button to
enter IP address, then press  button to enter
Subnet, Gateway and DNS respectively,
press the OK at "Set" to confirm the parameters.
 Note:
See page 59 for usage of Network.
of wired network of this
projector.
wired network of this
projector.
Display
Network setting
Network information
Color adjust
MAC address:
Setting IP address:
Expand
Memory
Viewer
Info.
----
LAN
Network setting
DHCP
IP address
Subnet
Gateway
DNS
Adjust Select
ENTER
LAN
Network setting
DHCP
IP address 192
192
Subnet
255
192
Gateway
DNS
192
Adjust Select
ENTER
Expand
Network
00:04:A3:97:69:DA
192.168.1.100
Select Back
OK Esc
On
Set
Cancel
Back
Esc
Off
168 1 100
168 1 100
255 255 0
168 1 1
168 1 1
Set
Cancel
Back
Esc
53