Appendix
Indicator and projector state
Check the indicator to know about the state of projector.
POWER
LAMP
RED/GREEN
GREEN
-
-
-
-
...Green
..Flash green
*When the projection lamp reaches its end of life, LAMP REPLACE indicator lights yellow.
Please replace the lamp with a new one.
66
Indicator
LAMP
WARNING
WARNING
REPLACE
TEMP
YELLOW
RED
-
-
-
-
-
-
-
-
-
...Red
...Flash red
State of projector
FILTER
RED
In power-off state (AC power cord not inserted).
-
In normal working state.
In standby state. Press POWER to power on the
-
projector
Ready to get in standby mode or the projection
lamp is being cooled. Before you power on the
-
projector, you should wait till the lamp is cool
enough and the power indicator stop flashes.
-
In Power manage state.
Internal temperature is too high. Can't be powered
-
on.
When the internal temperature of projector is
restored to the normal value, the power indicator
-
is illuminated red, and you can power on the
projector. Meanwhile, the indicator Warning Temp
stops flashing.
The service life of the lamp is over. You should
-
replace it with a new one in time.
Can't be powered on because error is detected.
You should unplug the power cord. Then insert it
again and power on the projector. If the projector
is powered off again, you should cut off the power
and contact the local distributor or repair center.
In this case, stop the projector. Otherwise, electric
shock or fire may occur.
Filter cleaning counter reach the time
...Yellow
...Flash yellow
- ...Normal operating
...Off