Remote Control; Factory Default - Eiki LC-XBS500 Owner's Manual

Expand

Remote control

Remote control
This switching function prevents remote control
interfering when operating several projectors
or video equipment at the same time.
The projector is assigned 10 different remote
control codes (Code 0-9), which are default
initial code (Code 0) and another 9 codes (code
1-9).
Code set on the projector and remote control
should be the same. For example, when using
code 7 to operate the projector, the remote
control code also must be switched to Code 7.
Change the projector's code: Select "Remote
control" in advanced menu.
Change the remote control code: Press the OK
button and a number key (0-9) on the remote
control for more than 5 seconds to switch the
codes. When the light start flashing, it means
code is completed.
RC sensor
Set RC sensor when using remote control to
operate projector.
Front .....Choose the front remote control
receiver.
Back .... .Choose the back remote control
receiver.
Both ..... Choose both front and back remote
control receivers.

Factory default

This function returns all setting values except
for the User logo, PIN code lock, Logo PIN
code lock, Lamp counter and Filter counter to
the factory default settings.
54
Display
Remote control
RC sensor
Color adjust
Setting
Expand
Memory
Viewer
Info.
Adjust
Light
Note:
● If the codes set on the projector and remote control
are different, it will not execute any operation. In
this case, switch the remote control code to the
same code as that of the projector.
● If the battery is removed for a long period of time
from the remote control, the remote control code
will be reset.
Display
Remote control
RC sensor
Color adjust
Setting
Expand
Memory
Viewer
Info.
Adjust
Return to factory default?
Move
OK
Remote control
Code 0
Select Back
OK Esc
Remote control
Code 0
Select Back
OK Esc
Yes
No
Select Back
Esc
Front
Front