Install Remote Control Batteries; Operating Range; Wired Remote Control Transmitter - Eiki LC-XBS500 Owner's Manual

Install remote control batteries

① Open the battery
cover.
To ensure safe operation, please observe the following precautions:
● Use two (2) AA or LR6 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked in the remote control, carefully wipe the case clean and
install new batteries.
● Risk of explosion if two batteries are replaced by an incorrect type.
● Dispose of used batteries according to the instructions on the battery or local
regulations or guides.

Operating range

Point the remote control toward the remote
control receivers on the projector (front and
back) when pressing any button.
The maximum operating range for the remote
control is about 5 meters and 60 degrees.

Wired Remote Control Transmitter

The remote control can be used as a wired
remote control. Wired remote control helps you
use the remote control outside of the operation
range (26.25'/8m). Connect the remote control
and the projector with the remote control cable.
Connected with the remote control cable, the
remote control does not emit wireless signal.
②Install new batteries.
Part names and functions
③
Two AA batteries
For correct polarity
(+ and –), be sure
battery terminals
are in contact
with pins in the
compartment.
30°
5m
30°
30°
5m
Put the cover
back.
15