Controlling Netaudio Server Parameters - Townshend Computer Tools DAT-Link User Manual

90
Loopback
Non-zero if loopback testing is enabled. Used only by the
gram.
It also possible to display exact values for the current VU levels and bu ering
available by adding the
-x
The package is used for screen updates. The screen must have at least
curses(3)
24 rows and 80 columns for proper display.

10.3 Controlling NetAudio Server Parameters

Various parameters of the
the client program. This program can be used whether or not recording
naset
or playback is currently underway | the changes take e ect immediately. Where
applicable, the changes can be limited to either the playback or record functions
by additionally specifying the
control are:
Gain:
This is an overall gain factor for playback or recording. The
is used to set this parameter.
naset
VU Decay:
The decay rate of the VU metering in dB/second. The default is 40
dB/second. This is set using the
Pause Control:
Playback or recording can be paused or resumed at any time
using the or
-p -r
audio output stream. Pausing record discards incoming samples.
Clock Source:
The clock source for playback and clock output from the external
clock connector can be speci ed using the
the following letters can be speci ed:
O:
Select the internal oscillator.
E:
Use the external clock connector as a clock input.
I:
Use the incoming digital audio data as the clock source.
G:
Output the clock on the external clock connector.
DSP Serial Mode:
This option allows the
be con gured. Once set, the mode selected remains in e ect until changed
by a subsequent
naset
followed by one of the following keywords. Note that many of these modes
are available only on the
and .
AES/EBU IR
option to the command.
DAT-Link
and the NetAudio server can be set using
or option respectively. The parameters under
-P -R
option.
-v
options. Pausing playback inserts zeroes into the digital
-S
DAT-Link
command. The serial mode is set using the
DAT-Link
+; the original
Utilities
naloop
option to
-g
option. Following the
-S
's DSP chip's serial port to
option
-s
DAT-Link
supports only
pro-
ag,