2.4 Machine Specic Instructions
Once you have veried that the information is correct, press the return key to enter
the conguration. If the conguration was successful, you should see a message
similar to the following:
Command: OK
Before command completion, additional instructions may
appear below.
rmt1 available
rmt1 available
The line
Your computer may indicate a dierent unit number for the device, such as
rmt2
or
. Make a note of which device name and number is displayed (
rmt2
or
). You will need it later.
F10
You can now press the
from outside
. Type the command:
smit
ln -s /dev/rmt1 /dev/datlink0
datlink0
to create the
system device. Note that
device name that was displayed when the device was congured by
You can now proceed with the software installation in Section 2.6 below.
2.4.6 Solbourne
Manufacturer:
Solbourne
Models:
S400DX
Operating System:
OS/MP 4.1A.3
Cables Required
To connect the workstation with the
high-density 50 pin D connector on one end and a 50 pin Centronics type connector
on the other end. This may also be called a SCSI-1 to SCSI-2 cable. It should
be available from your Solbourne hardware supplier or can be ordered from your
DAT-Link
supplier.
COMMAND STATUS
stdout: yes
DAT-Link
indicates that the
key to exit from
. One last thing needs to be done
smit
DAT-Link
stderr: no
has been congured as
rmt0
rmt1
should be replaced by the
.
smit
you will require a cable with a
23
rmt1
.
rmt0
rmt1
,
,
Need help?
Do you have a question about the DAT-Link and is the answer not in the manual?