Townshend Computer Tools DAT-Link User Manual page 34

30
the following instructions, we will assume that the device ID chosen was 4. If you
choose a di erent ID, make sure you replace \4" with the chosen ID before typing
any commands that follow.
Connecting the
DAT-Link
The next step is to connect the
unterminate the SCSI bus temporarily, it is recommended that you shut-down and
turn o the computer before making the connection.
The Options switches on the rear of the
down and the SCSI ID switch must be set as described above. Then connect the
DAT-Link
to the computer using the SCSI cable. If the
device on the SCSI bus, be sure to connect the provided SCSI terminator between
DAT-Link
the cable and the
with rebooting the computer. Once it is hooked up and powered on you can reboot
the computer. If you have trouble rebooting, verify that the SCSI ID selected on
DAT-Link
the was not one that was already in use.
As the computer starts, if you are using
to:
Target 4 TCT DAT-Link 1638
This above line shows that the system found the
DAT-Link
have con gured the
value in the above message.
You can now proceed with the software installation in Section 2.6.4 below.
Di erences in DOS Implementation
The NetAudio programs described elsewhere is this manual are available under
as individual executables. The usage of these tools di ers slightly from that
DOS
described elsewhere in this manual. In particular:
There is no NetAudio server (netaudiod or naserver) under

programs communicate directly with the
DAT-Link
that the
This means that programs such as
lasting e ect and are thus ine ective.
The argument to the -u option for each of the NetAudio clients should be the

SCSI address of the
form should be 'host:unit'.
DAT-Link
to the computer. Since it is necessary to
DAT-Link
's SCSI connector. Failure to do so can cause problems
ASPI4DOS
with a ID other than 4, you should see the selected
DAT-Link
will always be in it's default state when a tool is executed.
naset
DAT-Link
, even though the online help states that the
Installation
should be set with all switches
DAT-Link
is the last
, you should see a line similar
DAT-Link
at SCSI ID 4. If you
. All client
DOS
. Note that this means
and will not have a
naloaddsp