Townshend Computer Tools DAT-Link User Manual page 104

100
Figure 11.3: Controlling the DAT Machine from
directory. This con guration will be used for all subsequent recording until it is
modi ed using the setup panel again.
To initiate recording, click on the Start Recording button in the control panel.
Recording will actually begin about 1-2 seconds after clicking the button; watching
DAT-Link
the 's Record light will indicate exactly when recording has begun. The
recording will stop when the time speci ed in the setup menu is reached or earlier if
the Abort Recording button is clicked. In either case, when recording is completed,
a new window will be opened showing the recorded waveform.
waves+
The le created during recording will not be deleted automatically. To avoid lling
the disk with unneeded recordings, you must manually delete these les. Also, the
recording will not overwrite an existing le. Instead, the le name will have a digit
appended to it to make it unique.
The nal button on the DAT-Link Controls panel is Transport Controls . Clicking
on this button creates a new window, similar to that shown in Figure 11.3. Clicking
on any of the buttons in this new panel will perform the indicated function on the
DAT machine. The Other button opens a pop-up menu listing the less common
remote control functions. Note that the
Section 8, must have been set to the name of the DAT machine or remote device
before was started for this menu to work properly.
waves+
ERS
DAT-Link
The + can also be used with Entropic's ERS-2000 recording spectrogram.
DAT-Link
Contact your
For more information about ESPS, ERS, or
Research Laboratories directly at:
Entropic Research Laboratory, Inc.
600 Pennsylvania Ave SE
Suite 202
Washington, DC 20003
environment variable, described in
DL RC
supplier or Entropic Laboratories for details on this.
waves+
Third Party Support
waves+
, you should contact Entropic