Table of Contents
Advertisement
Installation
This section provides instructions for installing the CS 26T Plus speaker and the CS 120P
enclosure. Topics include:
•
•
•
•
•
•
Installation Considerations
WARNING: Potential risk of severe injury. Installation and service must be
AVERTISSEMENT :
•
•
•
Installation Configurations
The CS 26T Plus can be configured in the following ways:
•
•
For hard ceiling installations, see
page 32.
Installation Considerations
Installation Configurations
Installing the CS 1226T Plus — Single Installer
Installing the CS 120P in a Suspended Ceiling — Division of Labor
Installing the CS 26T Plus in a Suspended Ceiling — Division of Labor
Installing the CS 120P in a Hard Ceiling
performed by authorized personnel only.
Risque potentiel de blessure grave ou de mort. L'installation
et l'entretien doivent être effectués par le personnel autorisé uniquement.
All wiring and electrical connections must conform to all applicable building codes and
local ordinances.
Installation in a plenum-rated environment requires plenum rated cable or conduit.
If using secondary support cables, the installer provides the cables.
Open-back: For configurations in which the CS 120P is not used, use the C-ring
accessory, available at www.extron.com. The C-ring spreads out the clamping force of
the locking arms when used in drop ceilings and gypsum ceilings.
Using the CS 120P: When used with the CS 120P, the CS 26T Plus can be placed in
plenum environments. This is the only configuration that is UL 2043 rated.
NOTE: The CS 120P can be ordered separately or as part of the CS 1226T Plus kit.
Installing the CS 120P in a Hard Ceiling
CS 26T Plus and CS 120P User Guide • Installation
on
3
Advertisement
Table of Contents
