Table of Contents
Advertisement
Installing the CS 1226T Plus System — Single Installer
If a single installer is installing the CS 1226T Plus system, follow this procedure for the entire
system:
NOTE: The ceiling grid must be installed before the installation of the CS 1226T Plus
1.
2.
3.
begins.
•
Verify if fiberglass ceiling tiles are being used (see step 2 below and
page 7 for details).
•
The grid face should be at least 15/16 inch (24 mm), as shown below, for proper
installation of the CS 120P (see
enclosure on a smaller grid face).
Side View
Grid Face
15/16" (24 mm)
Figure 2.
Grid Face Example
Disconnect power
Power down all attached devices before proceeding.
—
Verify the space where the system will be installed — Ensure that there is sufficient
clearance above the ceiling tile for the unit to be installed.
Cut a hole for the CS 26T Plus speaker — Use the provided cutout template to
outline the hole to be cut in the ceiling tile as described below.
a.
Remove the ceiling tile.
b.
To find the center of the tile, use a tape measure to measure the space between
two opposite corners, and mark the half-way point.
c.
Position the center hole of the cutout template directly over the center of the tile
that you marked in step 3b.
d.
Using the provided cutout template, trace a circle on the ceiling tile as follows:
For installations in ceiling tiles that are NOT fiberglass or when installing
the speakers in an open back configuration: Trace a circle around the
CS 26T Plus cutout template.
NOTE: The fiberglass tile adapters are not needed and can be discarded.
step 21
on page 15 for details on suspending the
CS 26T Plus and CS 120P User Guide • Installation
step 11
on
4
Advertisement
Table of Contents
