Installing Into A Chassis; Suggested Minimum Chassis Dimensions - VIA Technologies EPIA-P910 User Manual

5.2. Installing into a Chassis

The EPIA-P910 can be fitted into any chassis that has the mounting holes
compatible with the standard Pico-ITX mounting hole locations. Additionally,
the chassis must meet the minimum height requirements for specified areas of
the mainboard.

5.2.1. Suggested minimum chassis dimensions

The figure below shows the suggested minimum space requirements that a
chassis should have in order to work well with the EPIA-P910.
Figure 29 Figure 29: Suggested minimum chassis dimensions : Suggested minimum chassis dimensions
Figure Figure 29 29 : Suggested minimum chassis dimensions : Suggested minimum chassis dimensions
Each side of the mainboard should have a buffer zone from the internal wall
of the chassis. The side of the mainboard that accommodates the I/O coastline
should have a buffer of 1.00 mm. The side on the opposite end of the I/O
coastline should have a buffer of at least 5.00 mm. The two sides adjacent to
the I/O coastline should have at least a 10.00 mm buffer.
EPIA- - - - P910 EPIA P910 User Manual User Manual
EPIA EPIA P910 P910 User Manual User Manual
40