Table of Contents
Advertisement
3. Hardware Installation
3.1. Installing into a Chassis
The VAB-630 can be fitted into any chassis that has the mounting holes compatible with the standard SBC
mounting holes locations. Additionally, the chassis must meet the minimum height requirements for
specified areas of the mainboard.
3.1.1. Suggested minimum chassis dimensions
The figure below shows the suggested minimum space requirements that a chassis should have in order to
work well with the VAB-630.
Figure 31: Suggested minimum chassis dimensions
Each side of the mainboard should have a buffer zone from the internal wall of the chassis. The side of the
mainboard that accommodates the I/O coastline should have a buffer of 1.5mm; it's comprised of a Mic-in,
Line-out, Micro USB 2.0 OTG, Micro SD card slot, DIO, Power LED and Power button. The side on the
opposite end of the I/O coastline should have a buffer of at least 1.5mm; it's comprised of DC-in jack,
HDMI, USB 2.0, 10/100Mbps Ethernet and COM. The two sides adjacent to the I/O coastline should have
at least a buffer 2.0mm.
3.1.2. Suggested minimum chassis height
The figure below shows the suggested minimum height requirements for the internal space of the chassis.
It is not necessary for the internal ceiling to be evenly flat. What is required is that the internal ceiling
height must be strictly observed for each section that is highlighted.
Figure 32: Suggested minimum internal ceiling height
1.5mm
2mm
1.5mm
19mm
17mm
19mm
VAB-630 User Manual
2mm
17mm
21
Advertisement
Table of Contents
