Lan Port: Gigabit Ethernet - VIA Technologies EPIA-P910 User Manual

2.1.1. LAN port: Gigabit Ethernet

The integrated 8-pin Gigabit Ethernet port is using an 8 Position 8 Contact
(8P8C) receptacle connector (commonly referred to as RJ45). The Gigabit
Ethernet ports are controlled by VIA Fast Ethernet controller. The pinout of
the Gigabit Ethernet port is shown below.
Pin Pin Signal Signal
Pin Pin Signal Signal
1 Signal pair 1+
2 Signal pair 1-
3 Signal pair 2+
4 Signal pair 3+
5 Signal pair 3-
6 Signal pair 2-
7 Signal pair 4+
8 Signal pair 4-
Table Table 3 3 3 3 : Gigabit Ethernet port pinout : Gigabit Ethernet port pinout
Table Table : Gigabit Ethernet port pinout : Gigabit Ethernet port pinout
The RJ-45 port has two individual LED indicators located on the front side to
show its Active/Link status and Speed status.
Link Off
Speed_10Mbit
Speed_100Mbit
Speed_1000Mbit The LED is always On in Orange color
Table Table Table Table 4 4 4 4 : Gigabit Ethernet LED color definition : Gigabit Ethernet LED color definition : Gigabit Ethernet LED color definition : Gigabit Ethernet LED color definition
Link LED Link LED Link LED Link LED
(Left LED on RJ- - - - 45 connector) (Left LED on RJ (Left LED on RJ (Left LED on RJ 45 connector) 45 connector) 45 connector)
Off
The LED is always On in either Green
or Orange colors
The LED is always On in Green color
Figure 5 5 5 5 : Gigabit Ethernet port pinout diagram Figure Figure Figure : Gigabit Ethernet port pinout diagram : Gigabit Ethernet port pinout diagram : Gigabit Ethernet port pinout diagram
(Right LED on RJ- - - - 45 connector) (Right LED on RJ (Right LED on RJ (Right LED on RJ
Flash in Yellow color
Flash in Yellow color
Flash in Yellow color
EPIA- - - - P910 EPIA P910 User Manual User Manual
EPIA EPIA P910 P910 User Manual User Manual
Active LED Active LED Active LED Active LED
45 connector) 45 connector) 45 connector)
Off
12