Hardware Installation; Installing Into A Chassis; Suggested Minimum Chassis Dimensions; Figure 48: Suggested Minimum Chassis Dimensions - VIA Technologies EPIA-M910 User Manual

VIA EPIA-M910 User Manual

5. Hardware Installation

5.1. Installing into a Chassis

The VIA EPIA-M910 can be fitted into any chassis that has the mounting holes for compatible with the
standard Mini-ITX mounting hole locations. Additionally, the chassis must meet the minimum height
requirements for specified areas of the board. If a riser card module is being used, the chassis will need to
accommodate the additional space requirements.

5.1.1. Suggested Minimum Chassis Dimensions

The figure below shows the suggested minimum space requirements that a chassis should have in order to
work well with the VIA EPIA-M910.

Figure 48: Suggested minimum chassis dimensions

Each side of the board should have a buffer zone from the internal wall of the chassis. The side of the
board that accommodates the I/O coastline should have a buffer of 1.00mm. The side on the opposite
end of the I/O coastline should have a buffer of at least 5.00mm. The two sides adjacent to the I/O
coastline should have at least a 10.00mm buffer.
For the side that is close to the PCI slot, the buffer should be at least 100.00mm if a riser card module
will be used.
49