Hardware Installation; Installing Into A Chassis; Suggested Minimum Chassis Dimensions; Figure 28: Suggested Minimum Chassis Dimensions - VIA Technologies VAB-1000 User Manual

Pico-itx cortex-a9 board

Hide thumbs Also See for VAB-1000:

Table of Contents

4. Hardware Installation

The VAB-1000 board can be fitted into any chassis that has the mounting holes for compatible with the

standard Pico-ITX mounting hole locations. Additionally, the chassis must meet the minimum height

requirements for specified areas of the board. If the VAB-1000-T I/O card is being used, the chassis will

need to accommodate the additional space requirements.

The figure below shows the suggested minimum space requirements that a chassis should have in order to

work well with the VAB-1000 board.

Each side of the board should have a buffer zone from the internal wall of the chassis. The side of the

board that accommodates the I/O coastline should have a buffer of 1.5mm. The side on the opposite end

of the I/O coastline that has SATA connector and board-to-board pin headers should have a buffer of at

least 12mm, or 27mm if the VAB-1000-T I/O card will be used. The two sides adjacent to the I/O

coastline should have at least a 2mm buffer.

VAB-1000 User Manual

Table of Contents