Accessing Service Menus; Configuration Menu - Lexmark C950 Service Manual

5058-030

Accessing service menus

Access the following menus to identify problems with the printer and run diagnostic tests.

Configuration Menu

Diagnostics Menu
Invalid engine mode
Recovery mode
Network SE Menu
Service Engineer
(SE) Menu
Service Manual
3-4
1. Turn off the printer.
2. Press and hold the 2 and 6
buttons simultaneously.
3. Turn on the printer.
4. Release the buttons after 10
seconds.
1. Turn off the printer.
2. Press and hold the 3 and 6
buttons simultaneously.
3. Turn on the printer.
4. Release the buttons after 10
seconds.
1. Turn off the printer.
2. Press and hold the 3, 4, and 6
buttons simultaneously.
3. Turn on the printer.
4. Release the buttons after 10
seconds.
1. Turn off the printer.
2. Press and hold the 7, 2, and 8
buttons simultaneously.
3. Turn on the printer.
4. Release the buttons after 10
seconds.
1. Touch .
2. Navigate to Networks/Ports >
Standard Network >
Std Network Setup.
3. Press and hold 6, 7, and 9
simultaneously.
From a Web browser on a host
PC, add /se to the printer IP
address.
The Configuration Menu group contains a set of
menus, settings, and operations which are
infrequently required by a user. Generally, the
options made available in this menu group are
used to configure a printer for operation.
See
"Configuration Menu" on page 3-5
information.
The Diagnostics Menu group consists of menus,
settings, and operations that are used to diagnose
various printer problems.
Note: While the Diagnostics Menu Group is active,
all host interfaces are offline.
See
"Diagnostics Menu" on page 3-14
information.
This mode is used if the machine has invalid code
and needs the correct code loaded. After entering
this mode, the firmware code can be updated.
This mode will allow the printer to boot from a
secondary set of instructions to allow a code flash
to the printer. Code can be flashed from a PC via
USB.
This menu contains settings for fine tuning the
communication settings for the network interfaces
and protocols.
See
"Service Engineer (SE) Menu" on
page 3-26.
Previous
Next
Go Back
for more
for more