Stepper Motor (Entrance/Paddle) And Belt (Entrance/Paddle) Removal - Lexmark C950 Service Manual

Reinstallation notes:
The tension of the belt (buffer/transport) (D) is automatically adjusted by the force of the spring attached to
•
the belt tensioner bracket (C).
Tighten the two screws in the order shown.
•

Stepper motor (entrance/paddle) and belt (entrance/paddle) removal

Remove the rear upper cover. See
1.
Loosen the two screws securing the belt tensioner bracket (A) to the finisher and move upward, as shown.
2.
Remove the belt (entrance/paddle) (B) from the stepper motor (entrance/paddle) (C).
3.
Connector
"Rear upper cover removal" on page
5058-030
E
B
4-306.
Repair information
Previous
Next
Go Back
4-343