5058-030
Release the two clamps (C) to release the harness.
4.
Swing the PCBA door open.
5.
Remove the two cables (D).
6.
Warning: When disconnecting the two wire harnesses from the motor, make sure that the release hook is
pressed or the connections will be damaged.
Remove the four screws (E) securing the fuser/lower redrive/1st BTR retract motor to the machine.
7.
Remove the fuser/lower redrive/1st BTR retract motor from the machine.
8.
Inner plate removal
Remove the printer front door. See
1.
2.
Remove the transfer belt cleaner. See
Remove the waste toner box.
3.
Service Manual
4-92
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
4-10.
4-172.
Previous
Next
Go Back